HLP FOR LOW VOLTAGES

Technical Data

The sheath of the cartridge heaters for low voltages is not ground (diameter 2.8 mm -0.1 mm; 4.5 mm ?0.1 mm and 5.0 mm ?0.1 mm) . The bottom end is welded gas and liquid tight. The maximum sheath temperature for the ? 2.8 mm and ? 4.5 mm heaters is approx. 500?C and 750?C for the ? 5.0 mm cartridges. The connection cable for the low voltage cartridge heater with diameter 2.8 and 4.5 mm consists of a 100 mm long twisted wire which is insulated by a teflon hose. The teflon insulation can withstand temperatures up to 300?C at short time use and 250?C for permanent use. The connection end of the ? 5.0 mm heating elements consists of a ? 2 mm connection bolt with a length of 20 mm.

Please note

Other lengths, voltages and powers can be supplied too.

The use of high performance cartridge heaters type HLP 2.8, HLP 4.5 with surface loading =20 W/cm2 is only permissible when there is a very good heat transfer. Cartridge heaters with a low surface load at 24 V can also be used for 42 V operation but it has to be considered that the power rating is more than 3 times higher.

High performance cartridge heaters designed for 24 V operation can also be used for 12 V operation but the power rating will then be reduced to a quarter of the nominal rating at 24 V.

Maximum current 8 A